If you are using the PedUSA pedometer supplied by Omada, you will first need to set it up so that it will measure your stride length and display the time correctly. You can set your stride length by following the instructions that came with your pedometer. We recommend that you determine your stride length before you begin the pedometer set-up process.
If you are using a different type or brand of pedometer, please refer to its manual for set-up instructions.
Turn the PedUSA pedometer on by removing the pedometer from the belt clip and pulling out the white arrow tab from the battery compartment.
Press SET. If "STEP" does not appear on the screen, use the MODE button to cycle through until it appears. The pedometer must be on the "STEP" screen (not "TOTAL STEP") to be set up.
Press and hold SET for 5 seconds until display flashes* :
- 12Hr or 24Hr will blink.
- Use RESET or MODE to select the clock display format.
- Press SET to confirm.
Next, set the time:
- The hours will blink.
- Use RESET or MODE to select the correct hour.
(If using 12Hr mode, "PM" will appear on screen if the hour is night; if no "PM" on the screen, the hour displayed is AM) - Press SET to confirm, and repeat to enter minutes.
- Press SET again.
Select distance units:
- IN will blink.
- Use RESET or MODE to select inches or centimeters.
- Press SET to confirm.
Adjust your stride length:
- A number will blink.
- Use MODE or RESET to enter the stride length calculated by following the instructions that came with your pedometer
- Press SET to confirm.
Enter weight:
- A number will blink.
- Use MODE or RESET to select your weight.
- Press SET to confirm.
Set step goal:
- A number will blink.
- Use MODE or RESET to set your step goal.
- Press SET to confirm
Your pedometer is now set up. Keep it with you and start walking!
*Note: When in setup mode, the display will automatically exit setup after 10 seconds. Press and hold SET for 5 seconds to enter setup mode again.